Vax Turbo Force V-060P Spezifikationen PDF herunterladen (Seite 33)

Tighten the bolts sufficiently to

make contact between the endplate and

the housing.

15. Coat vanes with oil and install the

vanes in the rotor. The vanes should

slide freely in the vane slots.

16. Locate the proper number of

gaskets and install them on the rear

endplate.

Do not use any gasket sealer.

Locate the two 10x50mm bolts used for

pulling the endplate and insert them in

bolt holes on either side of the endplate

to capture the gaskets.

17. Lubricate seal sleeve and install the

endplate on the end of the rotor and

carefully drive the endplate on the rotor.

18. When the endplate is close enough to the housing

install the endplate bolts lift the endplate-rotor

assembly to allow proper alignment of the bolts and

bolt holes and start the bolts into the housing.

Just prior to making contact with the housing, lift the

endplate-rotor assembly allow the endplate to enter

the housing.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 46 47

Keine Kommentare

Vax Turbo Force V-060P Spezifikationen Seite 33