Vax Turbo Force V-060P Spezifikationen PDF herunterladen (Seite 19)

Maintenance

• With force feed type, the lubrication rate is

adjustable at dripper and should be checked on a

regular basis. Oil should be supplied to pump at a

rate of 1 drop every 2 seconds.

• Average usage of oil is approximately 1 Gal. per 10

hours, depending on operation.

• Oil should be changed every 2000 hours in gear per

housing, if equipped.

• Front bearing should be greased approximately every

4 months. Use caution when greasing bearing not to

over grease, as this can cause damage to seals.

• Normal vane life is approximately 2000 hours;

however, this will vary greatly with temperature,

material being pumped and proper maintenance.

• Occasionally liquid and dirt may enter the pump

causing vanes to stick in the rotor slots along with

excessive vane and housing wear. When this occurs

you must clean the inside of the pump.

Cleaning the inside of the pump

• Remove air inlet hose or pressure relief valve.

• Run pump at an idle with the changeover valve in

neutral.

• Pour 1 pint of diesel fuel into pump through the air

inlet or fitting. Allow pump to run for 30 seconds

then turn the change over valve to vacuum.

• Repeat two steps above several times, and then pour

2 oz. of oil into the pump and reassemble.

• Stop pump and turn slowly by hand while listening

for vanes dropping. All vanes should move freely in

the rotor slot.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 46 47

Keine Kommentare

Vax Turbo Force V-060P Spezifikationen Seite 19