Vax Turbo Force V-060P Spezifikationen PDF herunterladen (Seite 16)

Lubrication procedure for all vacuum pumps on start up

(This procedure must be followed prior to the operation of a new

vacuum pump.):

• With force feed lubrication type, install dripper on

top of pump and connect rubber lines.*

• Remove dipstick and fill oil reservoir with

recommended turbine oil.

• With 540 RPM pumps: fill gear housing to level of

clear plastic sight plug on the side of the housing

with SAE 90 gear oil.

• Remove plastic cap on air inlet and pour 2 oz. turbine

oil into pump. Start pump slowly and with valve in

suction position, pour 2 oz. turbine oil into air inlet.

• At this point oil should be visible in the dripper or oil

lines. Adjust dripper flow to 1 drop every 2 seconds.

*Dripper will be shipped loose or taped to the bottom

of the changeover valve handle.

Automatic oil pump

• The automatic oil pumps are set at the factory

during pump testing and should require no further

adjustment during pump installation.

• The pumps are adjusted to one drop every two

seconds per outlet. This oil rate equals 2.7 fluid oz.

per hour.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 46 47

Keine Kommentare

Vax Turbo Force V-060P Spezifikationen Seite 16