Vax 4000 Model 200 Wartungshandbuch PDF herunterladen (Seite 81)

Appendix A

Starting and Modifying VMS

Factory-Installed Software

This appendix tells you how to start and modify VMS factory-installed

software (FIS), which is on your system disk if you ordered one or more

ISEs.

FIS must be modiﬁed to accommodate customized passwords and system

environment particulars. You make the modiﬁcations during a startup

procedure that is executed when you start FIS the ﬁrst time.

The requirements for modifying FIS depend on how your system will be

used. For example, your system can be conﬁgured as a:

• Standalone system

• Dual-host system

• Simple VAXcluster network

• System in a more complex VAXcluster network with distributed

resource sharing and sophisticated disk management

CAUTION: If you want to modify FIS to obtain a dual-host or VAXcluster

system, you should have a good understanding of DSSI architecture and

VAXcluster software operation. If you do not have that understanding, you

should read the manuals listed in Section A.1 or call your Digital service

representative.

A.1 Pre-Startup Requirements

Before you begin the startup procedure, you should:

1. Determine how your system will be conﬁgured.

2. Read through the startup procedure to make sure you have the correct

information to enter for your conﬁguration.

Starting and Modifying VMS Factory-Installed Software A–1

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 97 98

Keine Kommentare

Vax 4000 Model 200 Wartungshandbuch Seite 81