Vax 4000 Model 200 Wartungshandbuch PDF herunterladen (Seite 59)

8.1 Connecting the Q-bus Cables

Connect the two Q-bus cables (BC04V–09) to the two Q-bus Out connectors

on your system. Those connectors should be in the last (leftmost) backplane

slot used in your system. The module containing those connectors is labeled

M9404–PA.

Figure 31: Connecting the Q-bus Cables

Slide Down

to Lock

Connector

Locking Device

MLO-006573

1. Feed the plug end of one of the cables under the system from the back

or side and up through the opening. Then insert the plug end into the

lower Q-bus Out connector (J1). Secure the connection by sliding the

lock down.

2. Feed the socket end of the other cable under the system from the back

or side and up through the opening. Then insert the socket end into

the upper Q-bus Out connector (J2). Secure the connection by sliding

the lock down.

50 VAX 4000 Model 200 (BA430) Installation

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 97 98

Keine Kommentare

Vax 4000 Model 200 Wartungshandbuch Seite 59